thumbnail

Digital data set that describe aquifer characteristics of the Antlers aquifer in southeastern Oklahoma

Open-File Report 96-443

By:
, ,

Links

Abstract

ARC/INFO export and nonproprietary format file This diskette contains digitized aquifer boundaries and maps of hydraulic conductivity, recharge, and ground-water level elevation contours for the Antlers aquifer in southeastern Oklahoma. The Early Cretaceous-age Antlers Sandstone is an important source of water in an area that underlies about 4,400-square miles of all or part of Atoka, Bryan, Carter, Choctaw, Johnston, Love, Marshall, McCurtain, and Pushmataha Counties. The Antlers aquifer consists of sand, clay, conglomerate, and limestone in the outcrop area. The upper part of the Antlers aquifer consists of beds of sand, poorly cemented sandstone, sandy shale, silt, and clay. The Antlers aquifer is unconfined where it outcrops in about an 1,800-square-mile area. The recharge, hydraulic conductivity, and aquifer boundaries data sets include the outcrop area of the Antlers Sandstone in Oklahoma and areas where the Antlers is overlain by alluvial and terrace deposits and a few small thin outcrops of the Goodland Limestone. Most of the lines in these data sets were extracted from published digital geology data sets. Some of the lines were interpolated in areas where the Antlers aquifer is overlain by alluvial and terrace deposits near streams and rivers. The interpolated lines are very similar to the aquifer boundaries published in a ground-water modeling report for the Antlers aquifer. The maps from which this data set was derived were scanned or digitized from maps published at a scale of 1:250,000. The water-level elevation contours were digitized from a map at a scale of 1:250,000 that was used to prepare the final map published in a ground-water flow model report. Hydraulic conductivity and recharge values also are published in the ground-water model report for the Antlers aquifer. Ground-water flow models are numerical representations that simplify and aggregate natural systems. Models are not unique; different combinations of aquifer characteristics may produce similar results. Therefore, values of hydraulic conductivity and recharge used in the model and presented in this data set are not precise, but are within a reasonable range when compared to independently collected data.

Additional Publication Details

Publication type:
Report
Publication Subtype:
USGS Numbered Series
Title:
Digital data set that describe aquifer characteristics of the Antlers aquifer in southeastern Oklahoma
Series title:
Open-File Report
Series number:
96-443
Edition:
-
Year Published:
1997
Language:
ENGLISH
Publisher:
U.S. Geological Survey, Water Resources Division ; Available from the Earth Science Information Center, Open-file Reports Section,
Description:
1 computer disk :col. ;3 1/2 in.